Shop Biometric Door
Results 61 - 70 of about 558 for home alarm systems
 | Door Brace NON-MARRING YOKE: the door jam wireless home alarm (removable for sliding doors) is designed to work with most types of door hardware. Helps protect against finished damage. DESIGNED TO FIT MOST DOORS: Simple push button adjustment requires no tools HIGH STRENGTH STEEL TUBE: 20-gauge steel for greater strength PADDED FOOT: provides sure grip on most floor surfaces and protects against finish damage. PORTABLE: Collapsible, to fit in most suitcases and garment bags LIFETIME GUARANTEE Regular price: Sale Price: $17.95 USD You Save: $5.35! (23%)  |
 | |
 | House Hold Alert Receiver A complete customizable home alarm for under $100.00. This alarm is perfect for the dorm room, apartment or small home. The Household Alert Alarm allows you to monitor up to 4 different areas of your domicile. It?s the first system of its kind to give you full flexibility because you buy the alarm. You can choose any combination or up to 4 sensors that monitor anything from doors and windows, movement inside or outside your home, the garage door and even flooding! It?s simple and easy to set up and use. Since it is completely wireless you can set it up in less than one half an hour. All of the sensors (sold separately on this page) run on batteries. The main unit monitors the battery level and alerts you when a battery needs to be replaced. The system is so versatile that you can even use 2 or more separate receivers at the same time, allowing you to monitor your home from any room in your home. The system also alerts you in 2 ways; both audio and visual signals alert you to which zone has been triggered. If zone 1 is triggered you will see the zone 1 LED light and hear a single audible beep, if zone 2 is triggered you will see the zone 2 LED light and hear 2 beeps and so on for zones 3 and 4. The operating range is up to 300 feet and the unit is FCC/IC approved. #GM-318R $24.95 (sensors sold separately) Regular price: Sale Price: $24.95 USD You Save: $10.05! (29%) |
| |
 | Motion Sensor Add extra protection to your home or business with additional LaserShield ® Wireless Detection Units. The Wireless Detection Units communicate with the Master Alarm Unit via wireless radio signals and have a range of 150 Feet (without obstructions). Wireless Communication The Wireless Detection Units' use a wireless Radio Frequency (RF) to communicate with the Master Alarm Unit. Panic Button On the top of every Wireless Detection Unit is a large red button that functions the same as the one on the Master Alarm Unit. Pressing the panic button will immediately transmit a wireless signal to the LaserShield ® Master Alarm Unit and an alarm will be activated, notifying the 24 x 7 Rapid Response Monitoring Service. Power Connection The Wireless Detection Unit requires a power connection. There is no need for a phone line. Bypass Button A bypass button and indicator light is located under the motion sensor on the front of the unit. This button enables the user to bypass a bedroom Wireless Detection Unit at night. A small amber light will flash indicating the unit is in bypass mode. The bypass button does not affect the function of the panic button. Battery Back-Up The battery will provide up to 12 hours of back-up power. Pet Friendly A unique Pet Shield instantly snaps into place on the front of the LaserShield ® motion detector on the Wireless Detection Unit. The Pet Shield blocks portions of the motion sensor so your pet is less likely to trigger an alarm. Regular price: Sale Price: $64.95 USD You Save: $35.05! (35%) |
| |
 | Stun Flashlight (Large) Just about everyone has a flashlight-usually one in the car and at least one at home. That's why this cool stun gun flashlight is so great; no one suspects that this is an alarm and stun device. The 130 db alarms and are made of very sturdy fiberglass reinforced plastic. This handy little 80,000 volt stun gun flashlight is also a 130 db alarm. The body is made of fiberglass reinforced plastic. Uses one 9-volt alkaline battery. 18" long NOTE: WE WILL NOT SELL TO OR SHIP TO THE FOLLOWING STATES District of Columbia, Hawaii, Illinois, Massachusetts, Michigan, New Jersey, New York, Rhode Island, Wisconsin or outside the United States. In Iowa and Mississippi a permit is required to legally possess a stun gun or taser. Be sure to check your local laws before placing your order. Regular price: Sale Price: $74.95 USD You Save: $22.45! (23%) |
| |
 | Key Fob Remote Control for Tattletale Mobile Alarm System One button control in the palm of your hand. The Keychain Remote Control can be used to arm or disarm your system or send a panic signal from up to 2000 feet away from the tattletale depending on structures and objects in-between. The 3.0V Lithium Battery that is included will typically last for 3-5 years. *Requires TattleTale Base unit or starter kit below *See PDF for system overview Regular price: Sale Price: $99.00 USD You Save: $51.00! (34%) |
| |
 | 2.4Ghz Receiver w / Switcher 2.4Ghz Receiver + 4CH Switcher w/ Alarm Function Regular price: Sale Price: $125.60 USD You Save: $35.17! (22%) |
| |
 | Cube Clock Covert Camera With a Cube Clock Covert Camera, you can keep an eye on things, even when you're not around. The Cube Alarm Clock Radio is a fully functioning Plug & Play Surveillance System, with a high quality CCD Camera built inside, the Camera is virtually hidden. Includes Hidden Video Camera Systems Power Supply RCA CableInstructions Size 4 3/4" x 4 3/4" x 4 3/4" Regular price: Sale Price: $149.95 USD You Save: $20.05! (12%) |
| |
 | Dakota Alert Alarm Kit, (1) IR-3000 and (1) WR-3000 Infrared Sensor Three Different Sensitivity Settings Low Battery Alert Designed for Indoor or Light Duty Outdoor Four Different Tones Volume Control The passive infrared detector is able to monitor an area up to 100° wide. With the integral mask, the detection area can be narrowed down to 20° or anywhere in between. With the swivel mount, the IR-3000 sensor can be adjusted right to left up to 80° and up and down up to 50°. With three different sensitivity settings, the IR-3000 can detect a person up to 12 feet, 25 feet or 40 feet away. The sensor can also be set to flash an LED or stay dark when a signal is sent. The IR-3000 is powered by one 9 volt battery and will have a battery life of about 12 months under normal conditions. There is also a low battery alert to notify you when it is time to replace the battery. The IR-3000 is designed for indoor or light duty outdoor applications under an eave or awning or other protected locations. The WR-3000 is the receiver for the IRWR-3000 system. The WR-3000 plugs into a standard wall outlet and can be placed on a table or ounted on the wall. When the receiver gets a signal from the transmitter, one of four different tones (Classical, Westminster Chime, Ding Dong, or Whistle) will sound for a few seconds. There is also a volume control, allowing you to set the sound to the desired level. The WR-3000 is equipped with four form "C" relays (one for each zone), and one 12-volt DC output terminal that will activate for several seconds when a signal is received. The receiver can be user-programmed, so the 12-volt DC terminal and one relay will activate for 10 minutes, if this is desired. The tones will still sound for several seconds. Regular price: Sale Price: $159.95 USD You Save: $50.05! (24%) |
| |
 | Motion Detector BW Camera with DVR built-In The Memo Cam™ is a complete stand-alone CCTV System in one device. It includes a CCD Camera, a Video compression engine, a Multi-Media Card & PIR Detector.When used as a stand-alone unit, it automatically records events on the MMC following an alarm. The alarm can be activated by an external open contact or by the internal PIR detector.To analyze the recorded events, the Multi-Media Card can be removed from the Memo Cam™ unit & inserted in a multi-media card reader connected to a PC.A Remote Control unit enables you to activate/deactivate the Automatic Event Recording process or to record an event manually.? Stand-alone integrated CCTV System packaged in a standard PIR Detector case ? Records up to 12,000 images on a 128MB Multi-Media Card (Unit now available with 16MB MMC) ? Automatic recording upon alarm ? Pre & post alarm recording ? View playback or recorded video images ? Download the recorded events to a PC ? Automatic setup by MultiMedia Card ? Ultimate image quality ? Fully functioning PIR detector ? Standard removable MultiMedia Card ? Remote control unit ? Black & White Camera ? Covert case Benefits ? The stand-alone MemoCam replaces the classic [Time Lapse VCR + PIR Detector + Camera] equipment set ? Modular CCTV solution from single camera to multiple site/multiple camera systems ? Economic system expansion ? No video cables required Applications ? Recording of images & events where wire connections are impossible or difficult ? "Nanny control" - Unattended automatic recording at any site ? Modular digital CCTV systems in places where the required number of attached cameras might increase beyond initial plans ? Mobile applications Regular price: Sale Price: $499.95 USD You Save: $200.05! (29%) |
| |
 | Griffid SSPro Network Camera Software Griffid Supported Cameras & Digital Video Recorders: http://www.griffid.com/htm/camerint_one.html GRIFFID SURVEILLANCE STATION BASE LICENSE IS REQUIRED FOR 1 CAMERA APPLICATIION. System Requirements: Windows 2000 pro or XP pro Internet Explorer 6.0 or higher Pentium 4 2.4 Ghz or higher 256MB RAM An Internet connection like ADSL /T1/T3/cable if remote monitoring is enabled. Features: Live streaming from single/multiple cameras and recording at the same time. High quality images stored in single jpeg format. Easy installation and configuration of cameras. Motion detection with masking options. Alarm on No-Motion for production monitoring. Options for external alarms, like PIRs, access controls, burglar alarm, gate opener, etc. Web browser interface to view live images as well as recorded images via LAN or Internet. Secure login using encrypted passwords. High-speed recording up to 10FPS on each camera. Wake-on-Alarm built into the product gives you automatic client start up when motion is detected or an external alarm is triggered. Support for Pan/Tilt/Zoom cameras including preset positions. Support for full duplex audio Warnings on altered or deleted images Surveillance Station Pro Software License: This is a license ONLY for Surveillance Station Pro software for one camera application, that then allows you to download the software from Griffid. Griffid Surveillance software is a complete digital surveillance solution that can be very easily integrated with your existing surveillance system. This software can be used with network cameras, web enabled ip cams, as well as analog cameras. It allows to view and record live images while reviewing recorded events. The big advantage of Griffid Surveillance Station is that it offers secure access from any location to the live images as well as the recorded events. It also offers integration with other alarm systems, surveillance centers or production automation software. This is an advanced .NET solution that supports 1 to 36 cameras and brings you live images as well as high speed digital recording to hard disks. The live images can be viewed in many modes, like 4, 6, 9, 10, 13 and 16 cameras at the same time, but also more sophisticated modes like Show-On-Alarm and switching views providing the end-user the option to customize the software. A new release supporting Pocket PC to be announced shortly, it will enable remote view and function activation from a wireless PDA. Regular price: Sale Price: $559.95 USD You Save: $90.05! (14%) |
| |
Popular searches related to: home alarm systems
